Home

Computers to control irrigators. Irrigators controlled by Program Rain or Constant Rain will run precisely and therefore the irrigation is always correct. The equipment is robust and reliable, and the main program is used for many years.

Program Rain 10-12:



Program Rain 10-12 features:

Speed regulation
Pre- and post-irrigation
4 different speeds
Clock
Start time is adjustable
Stop time is shown in the display
Length of the pipe
Actual speed
Battery voltage
Charge regulation
Pressure sensor
Stop sensor
Speed sensor
Motor 1, regulation motor
Motor 2, stop motor
Slowly start of turbine
Slowly opening for inlet of water
GSM SMS messaging for remote control

The time to retract is shown in the display all the time.

Run by formula:
Program Rain can be used without measure roller.
A disk with 4 or 6 magnets can be fitted to the slow running small drive sprocket on the gear.
A sensor type 5 double sensor must be used.
For Program Rain, to calculate the drum circumference depending on tube layers, some constants must be defined.
It must be done by the supplier at delivery time.
The following constants for machine data must be set:
Pipe length – pipe diameter – inner drum diameter – windings pr. layer – large drive sprockets – small drive sprockets - number of magnets on the disk.

Nortoft Electronic A/S,   Sejrupvej 38,   DK 7323 Give.   T: +45 7573 6078   F: +45 7573 6118   www.nortoftelectronic.com